This paper proposes a high-power-density 150 GHz phased-array transceiver designed for 6G user equipment (UE) modules, utilizing $65-\text{nm}$ CMOS technology. An 8 -element AiP module using two transceiver ICs operates in the 142-164 GHz frequency range, achieving an EIRP of 26 dBm and a maximum data rate of 56 Gbps. The power consumption per element is 150 mW in TX mode and 93 mW in RX mode.
A microstrip antenna radiating towards the substrate edge is proposed for 150 GHz band Antenna-in-Package applications, designed to suppress mutual coupling between antenna elements. By incorporating side ground walls made of vias and copper foil around the radiating elements, the symmetry of the radiation pattern is enhanced. This structure improves mutual coupling by approximately 10 dB compared to configurations without side ground walls and enhances the operational gain during beam scanning by 2.1 dB in the -30 degree direction.
TEG chips were assembled on 2.3D i-THOP (integrated-Thin film High density Organic Package) and reliability tests were conducted at the package level. It was confirmed that low CTE UFR (Underfill Resin) is required using organic interposer for heterogeneous integration. For large packages, it is important to optimize the design of a package structure that reduces warpage, in addition to applying an UFR with high flowability.
In recent years, data have been exchanged by communication terminals everywhere in our daily lives, and the development of low-latency communication technologies for use in medical devices, factory automation, and autonomous driving has been gaining momentum. In order to meet the increasing demand for communications in the future, MIMO (Multiple Input Multiple Output) using the sub-THz band, which has a wider bandwidth available, is expected to realize even higher speed and capacity communications. At frequencies of 151.5 to 164 GHz, the wavelength is approximately 1.9 mm, so a multi-element compact antenna module with antennas of 1 mm or less in line can be realized. Challenges to the widespread use of MIMO antenna modules for high-frequency applications are transmission loss due to the increased number of wiring paths associated with the increased number of antenna elements, and miniaturization for installation in edge devices. In this development, we attempted to solve the problem of transmission loss by selecting low dielectric constant and low dielectric loss tangent materials and using the latest printed circuit board technology to create an antenna with a waveguide that is easy to mass-produce. We also Developed a coreless substrate process to produce small AiP (Antenna-In-Package) substrates that can be miniaturized and reduction in height. Environmental load tests (-55 ⇔ 125 deg.C) were conducted on the prototype AiP substrate, and the 7 stacked via passed 1000 cycles, confirming its practical reliability. The substrate size of this AiP is 8mm x 20mm x <1mmt, which is small enough to be mounted on wearable devices with narrow mounting areas, and it is expected to be widely used in society.
We have developed polymer optical waveguides (PWGs) for die-to-die optical interconnection. To realize this application, we defined the required specifications for the PWGs and evaluated its performance using a direct imaging (DI) exposure system.