
The main component of the printing ink binder is pine resin rosin. This work examines the composition and properties of metallized paint based on rosin derived from cherry tree resin in order to reduce the percentage of imported components and expand the range of metallized paints. The composition of metallized paint based on rosin from cherry tree resin was studied by IR spectroscopy. A comparative analysis of the infrared spectra of paints based on rosin from cherry tree resin and those made in China, taken for comparison, showed their chemical identity. The stability of the paint was determined using stand-ard methods and was characterized by its drying time on a non-absorbent surface. It was revealed that paint made from al-ternative raw materials has a shorter drying time, which is one of the necessary conditions for the offset printing process. The potential of IR spectroscopy as a method in printing ink production is demonstrated by its efficiency and ability to accurately determine the chemical composition and degree of similarity to reference samples. Using a paint with an identical composition based on cherry tree resin rosin can help address raw material shortages and expand the range of printing inks.
Studies of the surface tension at the interface between aqueous and saline solution of hydrochloric acid Armoflote 619–air have shown that the salt of alkylmorpholine is not prone to precipitation even in saturated solutions. The study of the foaming ability of the hydrochloric acid salt of Armoflote 619 in both aqueous and saline solutions, up to saturated ones, showed the high resistance of the salt of Armoflote 619 to the precipitating effect of inorganic electrolytes. For the enrichment of polymineral ore the optimal composition and density of the flotation solution were selected. It is a water magnesium chloride solution with a density of 1 295 kg/m 3 , presaturated with ore to a density of 1 305 kg/m 3 . It has been established that the use of acidified flotation solution with pH 3–4 leads to an increase in the extraction of halite into the foam product. The recovery of NaCl is 95–96 %. The acidic environment of the flotation solution leads to a decrease in KCl losses by 1.3 times and MgSO 4 by 2.8 times. The accumulation of alkylmorpholine in flotation solution helps to reduce the collector consumption during flotation in circulating brines: if in the primary brine 89,55 % of sodium chloride can be extracted from the ore at the consumption of alkylmorpholine of 460 g/t, then during flotation in the brine of the 8th recirculating cycle at the consumption of 160 g/t of ore, 94,57 % of it is extracted.
The article presents the results of kaempferol and its glycosides identification in plant extracts using the method of high-performance chromatography-mass spectrometry (HPLC-MS). The study is focused on the selection and optimization of chromatographic conditions for efficient separation and identification of these flavonoids with high biological activity, as well as at searching for new types of plant raw materials for the pharmaceutical industry of the Republic of Belarus. The use of the mass-spectrometric and spectrophotometric detection ensured high sensitivity and selectivity in the identification of kaempferol and its glycosides. Astragalin in an amount of more than 2.20 mg/g of absolutely dry raw material is contained in the extracts of Asclepias incarnate L., Geranium pratense L. and Glycyrrhiza uralensis Fisch. ex DC. Three glycosides of kaempferol were also identified in Glycyrrhiza uralensis Fisch. and Glycyrrhiza glabra L. extracts, and two glycosides – in the extracts of Borago officinalis L. The conducted study demonstrates the efficiency of the HPLC-MS method for analyzing flavonoids in multicomponent plant matrices and can be used for the quality control of plant raw materials and in pharmacognosy.
A comparative analysis of the efficiency of milk protein hydrolysis by trypsin and neutral protease using different methods of their addition was conducted. It was found that proteolysis by trypsin (enzyme-substrate ratio 1 : 40) at a temperature 37 °C and pH 8.0 leads to the formation of 81.2 ± 5.5 % of peptides with molecular mass less than 3.0 kDa, while protein hydrolysis by neutral protease (enzyme-substrate ratio 1 : 20) under the same conditions produces 86.6 ± 4.7 % of low molecular weight peptide fractions. It was shown that sequential application of trypsin and neutral protease allows obtaining, on average, 94.9 % of short peptides in comparison with the joint addition (91.3 ± 1.1 % of low molecular weight peptides). The application of the single enzyme provides the production of partial hydrolysates that can be used in the formulation of functional foods with reduced allergenicity, while the sequential and joint addition of trypsin and neutral protease generates extensive hydrolysates, which are considered optimal ingredients in the creation of hypoallergenic food products.
Hybrid composites based on calcium carbonate-phosphates and fibrin were obtained by wet precipitation in presence of citrated plasma (6–50 vol.%). Inorganic component of the composites represents amorphous calcium carbonatephosphates and amorphized carbonated hydroxyapatite (A-type) with a Ca/P ratio of 1.71. After 15 days of aging in the SBF model solution, the hybrid composites are enriched with biomimetic apatite (up to 8.8 wt.%) without changing of Ca/P ratio of 1.71. Fibrin macromolecules provide partial removal of CO32–ions from the structure of hybrid composites and apatite-forming capacity in the model SBF solution. Hybrid composites absorb up to 92 % of ciprofloxacin from aqueous solutions; the sorption capacity reaches 0.126 mmol/g. During 10 days of soaking in physiological solution, the composites release up to 89 % of the antibiotic; rate constant of ciprofloxacin release for composites measures 0,021 mmol/(g ∙ h0.25) versus 0,051 mmol/(g ∙ h0.10) for calcium carbonate-phosphates