BackgroundGlyphosate (GLP) is a widely used herbicide with possible adverse effects on human health and the environment. In soils, GLP strongly adsorbs on clay-sized minerals, depending on pH, the amount of organic carbon, as well as the contents and properties of Al and Fe oxyhydroxides and clay minerals. Many clay-sized minerals have already been investigated regarding GLP adsorption behavior, but information on minerals commonly found in volcanic soils is still lacking. AimThe aim of this study was to investigate for the first time the pH-dependent adsorption of GLP on allophane and halloysite, typical minerals found in volcanic soils. MethodsGLP adsorption was studied in batch experiments at three pH values (5, 6, and 7). Synthetic allophanes with two different initial Al:Si ratios (1.4 and 1.8) and a halloysite were used as adsorbents. ResultsThe adsorption capacity (AC) increased with rising Al:Si ratio and decreasing pH. The AC of allophane was significantly higher than that of halloysite. GLP adsorption on allophane was larger than that reported for other clay minerals and Al and Fe oxyhydroxides, especially at low pH. The AC of halloysite was higher than reported for most other clay minerals. ConclusionDifferent mineral formation pathways in volcanic soils, notably the formation of halloysite versus allophanes, strongly affect the soils' retention capacity for GLP. The high AC of allophanes may induce the low mobility of GLP in allophane-containing soils. Long-term use of GLP may accumulate the herbicide in these soils with potential effects on biodiversity and ecosystem services.

We report here on structure-related aggregation effects of short-range ordered aluminosilicates (SROAS) that have to be considered in the development of synthesis protocols and may be relevant for the properties of SROAS in the environment. We synthesized SROAS of variable composition by neutralizing aqueous aluminium chloride with sodium orthosilicate at ambient temperature and pressure. We determined elemental composition, visualized morphology by microscopic techniques, and resolved mineral structure by solid-state 29Si and 27Al nuclear magnetic resonance and Fourier-transform infrared spectroscopy. Nitrogen sorption revealed substantial surface loss of Al-rich SROAS that resembled proto-imogolite formed in soils and sediments due to aggregation upon freezing. The effect was less pronounced in Si-rich SROAS, indicating a structure-dependent effect on spatial arrangement of mass at the submicron scale. Cryomilling efficiently fractured aggregates but did not change the magnitude of specific surface area. Since accessibility of surface functional groups is a prerequisite for sequestration of substances, elucidating physical and chemical processes of aggregation as a function of composition and crystallinity may improve our understanding of the reactivity of SROAS in the environment.

Polymer brush-grafted superparamagnetic iron oxide nanoparticles can change their aggregation state in response to temperature and are potential smart materials for many applications. Recently, the shell morphology imposed by grafting to a nanoparticle core was shown to strongly influence the thermoresponsiveness through a coupling of intrashell solubility transitions and nanoparticle aggregation. We investigate how a change from linear to cyclic polymer topology affects the thermoresponsiveness of poly(2-isopropyl-2-oxazoline) brush-grafted superparamagnetic iron oxide nanoparticles. Linear and cyclic polymers with three different molecular weights (7, 18, and 24.5 kg mol-1) on two different core sizes (3.7 and 9.2 nm) and as free polymer were investigated. We observed the critical flocculation temperature (CFT) during temperature cycling dynamic light scattering experiments, the critical solution temperature (CST), and the transition enthalpy per monomer during differential scanning calorimetry measurements. When all conditions are identical, cyclic polymers increase the colloidal stability and the critical flocculation temperature compared to their linear counterparts. Furthermore, the cyclic polymer shows only one uniform transition, while we observe multiple transitions for the linear polymer shells. We link the single transition and higher colloidal stability to the absence in cyclic PiPrOx shells of a dilute outer part where the particle shells can interdigitate.

Coating processes are commonly used in materials science to protect a core or modify material properties. We describe a hydrothermal coating process using TEOS (tetraethyl orthosilicate), a widely used precursor for silica coatings, on three representative template materials (carbon nanotubes, silica, and polystyrene nanoparticles) with different properties and shapes. We compare the efficiency of previously published protocols for silica coatings at room temperature and atmospheric pressure with the hydrothermal process at 160 °C and 3 bar. The hydrothermal method achieves higher yields and thicker silica coatings with the same amount of precursor when compared to the conventional way, thus offering higher effectiveness. Furthermore, the hydrothermal coating process yields more homogeneous shells with a higher density, making hydrothermal coating the method of choice when mechanical integrity and low permeability of the coating are required.

Herein, we show a comprehensive experimental, theoretical, and computational study aimed at designing macromolecules able to adsorb a cargo at the nanoscale. Specifically, we focus on the adsorption properties of star diblock copolymers, i.e., macromolecules made by a number f of H-T diblock copolymer arms tethered on a central core; the H monomeric heads, which are closer to the tethering point, are attractive toward a specific target, while the T monomeric tails are neutral to the cargo. Experimentally, we exploited the adaptability of poly(2-oxazoline)s (POxs) to realize block copolymer-coated nanoparticles with a proper functionalization able to interact with heavy metals and show or exhibit a thermoresponsive behavior in aqueous solution. We here present the synthesis and analysis of the properties of a high molecular mass block copolymer featured by (i) a polar side chain, capable of exploiting electrostatic and hydrophilic interaction with a predetermined cargo, and (ii) a thermoresponsive scaffold, able to change the interaction with the media by tuning the temperature. Afterward, the obtained polymers were grafted onto iron oxide nanoparticles and the thermoresponsive properties were investigated. Through isothermal titration calorimetry, we then analyzed the adsorption properties of the synthesized superparamagnetic nanoparticles for heavy metal ions in aqueous solution. Additionally, we use a combination of scaling theories and simulations to link equilibrium properties of the system to a prediction of the loading properties as a function of size ratio and effective interactions between the considered species. The comparison between experimental results on adsorption and theoretical prediction validates the whole design process.

Linear and cyclic poly(2-ethyl-2-oxazoline) (PEOXA) adsorbates provide excellent colloidal stability to superparamagnetic iron oxide nanoparticles (FexOy NPs) within protein-rich media. However, dense shells of linear PEOXA brushes cannot prevent weak but significant attractive interactions with human serum albumin. In contrast, their cyclic PEOXA counterparts quantitatively hinder protein adsorption, as demonstrated by a combination of dynamic light scattering and isothermal titration calorimetry. The cyclic PEOXA brushes generate NP shells that are denser and more compact than their linear counterparts, entirely preventing the formation of a protein corona as well as aggregation, even when the lower critical solution temperature of PEOXA in a physiological buffer is reached.